Cisco Unified Wireless IP Phone 7925G,
7925G-EX, and 7926G Setup
•
Before You Begin, page 1
•
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Installation, page 8
•
Bulk Provisioning, page 17
•
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Startup, page 17
•
Phone Startup Process, page 18
Before You Begin
Before installing a Cisco Unified Wireless IP Phone, review the requirements in the following sections.
Network Requirements
For the Cisco Unified Wireless IP Phone to successfully operate as a Cisco Unified IP Phone endpoint, your
network must support these requirements:
•
Voice over Wireless LAN
◦
Cisco Aironet Access Points (APs) configured to support Voice over WLAN (VoWLAN)
◦
Controllers and switches configured to support VoWLAN
◦
Security implemented for authenticating wireless voice devices and users
You must verify that your wireless network is configured properly for voice service.Note
•
VoIP Network
◦
Cisco routers and gateways configured for VoIP
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
1