Cisco 7925G Installing Guide

Use CSA or ATEX qualified Bluetooth accessories with the Cisco Unified IP Wireless Phone 7925G-EX
in hazardous environments.
Warning
Battery Safety Notices
These battery safety notices apply to the batteries that are approved by the Cisco Unified Wireless IP Phone
manufacturer.
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions. Statement 1015
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
Do not dispose of the battery pack in fire or water. The battery may explode if placed in a fire.Warning
The battery pack is intended for use only with this device.Caution
Do not disassemble, crush, puncture, or incinerate the battery pack.Caution
To avoid risk of fire, burns, or damage to your battery pack, do not allow a metal object to touch the battery
contacts.
Caution
Handle a damaged or leaking battery with extreme care. If you come in contact with the electrolyte, wash
the exposed area with soap and water. If the electrolyte has come in contact with the eye, flush the eye
with water for 15 minutes and seek medical attention.
Caution
Do not charge the battery pack if the ambient temperature exceeds 104 degrees Fahrenheit (40 degrees
Celsius).
Caution
Do not expose the battery pack to high storage temperatures (above 140 degrees Fahrenheit, 60 degrees
Celsius).
Caution
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
6
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup
Safety Information

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g