Cisco 7925G Installing Guide

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
Warning
Read the installation instructions before connecting the system to the power source. Statement 1004Warning
This equipment will not be able to access emergency services during a power outage because of reliance
on utility power for normal operation. Alternative arrangements should be made for access to emergency
services. Access to emergency services can be affected by any call-barring function of this equipment.
Warning
Do not use the Cisco Unified Wireless IP Phone 7925G and 7926G in hazardous environments such as
areas where high levels of explosive gas may be present. Check with the site safety engineer before using
any type of wireless device in such an environment.
Warning
The plug-socket combination for the battery charger must be accessible at all times, because it serves as
the main disconnecting device. Statement 1019
Warning
The battery charger requires short-circuit (overcurrent) protection to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations. Statement 1045
Warning
The power supply must be placed indoors. Statement 331Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
Telephone receivers produce a magnetic field that can attract small magnetic objects such as pins and
staples. To avoid the possibility of injury, do not place the handset where such objects may be picked up.
Warning
The battery charger used with Cisco Unified IP Wireless Phone 7925G-EX is not ATEX or CSA certified
and as such it should not be charged in hazardous environment.
Warning
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
5
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup
Safety Information

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g