EasyManuals Logo

Cisco 800 Series Hardware Installation Guide

Cisco 800 Series
292 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #262 background imageLoading...
Page #262 background image
4-6
Cisco Integrated Services Router Hardware Installation Guide
Chapter 4 Initial Configuration
Cisco 860, 880, 890 Series
The configuration is displayed:
The following configuration command script was created:
hostname Router
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet4
no shutdown
speed 100
duplex auto
ip address 172.1.2.3 255.255.0.0
!
Step 12 Respond to the following prompts. Enter 2 to save the initial configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
Router>
Step 13 Verify the initial configuration. See the “Verifying the Initial Configuration” section on page 4-2 for
verification procedures.
After the initial configuration file is created, you can use the Cisco IOS CLI to perform additional
configuration.
Verifying the Initial Configuration
To verify that the new interfaces are operating correctly, perform the following tests:
To verify that the interfaces and line protocol are in the correct state—up or down—enter the show
interfaces command.
To display a summary status of the interfaces configured for IP, enter the show ip interface brief
command.
To verify that you configured the correct hostname and password, enter the show configuration
command.
After you complete and verify the initial configuration, you can configure your Cisco router for specific
functions.

Table of Contents

Other manuals for Cisco 800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 800 Series and is the answer not in the manual?

Cisco 800 Series Specifications

General IconGeneral
ModelCisco 800 Series
CategoryNetwork Router
VPN SupportYes
FirewallYes
DimensionsVaries by model
ProcessorVaries by model
MemoryVaries by model
Operating SystemCisco IOS
WAN PortsVaries by model
LAN PortsVaries by model
WAN InterfacesVaries by model
LAN InterfacesFast Ethernet or Gigabit Ethernet

Related product manuals