DescriptionParameter
Can be blank if not needed.
With the LDAP number mapping, you can manipulate
the number that was retrieved from the LDAP server.
For example, you can append 9 to the number if your
dial plan requires a user to enter 9 before dialing. Add
the 9 prefix by adding (<:9xx.>) to the LDAP Number
Mapping field. For example, 555 1212 would become
9555 1212.
Note
If you do not manipulate the number in this fashion, a user can
use the Edit Dial feature to edit the number before dialing out.
Default: Blank
Number Mapping
Programmable Softkeys
DescriptionParameter
Enables programmable softkeys.Programmable Softkey Enable
Softkeys that display when the phone is idle.Idle Key List
Softkeys that display when there is a missed call.Missed Call Key List
Softkeys that display when the phone is off-hook.Off Hook Key List
Softkeys that display when the user must enter dialing
data.
Dialing Input Key List
Softkeys that display when a call is attempting to
connect.
Progressing Key List
Softkeys that display when a call is connected.Connected Key List
Softkeys that display when a call transfer has been
initiated.
Start-Xfer Key List
Softkeys that display when a conference call has been
initiated.
Start-Conf Key List
Softkeys that display when a conference call is in
progress.
Conferencing Key List
Softkeys that display when a call is released.Releasing Key List
Softkeys that display when one or more calls are on
hold.
Hold Key List
Softkeys that display when a call is incoming.
To silence an incoming call, you can add Ignore
softkey.
Ringing Key List
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
318
Cisco IP Phone Troubleshooting
Programmable Softkeys
To Next Page
Loading...
Need help?
General
