DescriptionDefaultField Type
or Choices
Field
Select speed and duplex of the network port.
If the phone is connected to a switch, configure the port on the
switch to the same speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you must change the PC
Port config option to the same setting.
AutoAuto
10MB half
10MB full
100MB half
100MB full
1000 full
Switch port config
Select Speed and duplex of the Computer (access) port.
If the phone is connected to a switch, configure the port on the
switch to the same speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you must change the
Switch Port config option to the same setting.
AutoAuto
10MB half
10MB full
100 MB half
100MB full
100 half
1000 full
PC port config
Enable or disable Cisco Discovery Protocol (CDP).
CDP is a device-discovery protocol that runs on all Cisco
manufactured equipment.
Using CDP, a device can advertise its existence to other devices
and receive information about other devices in the network.
OnOn
Off
CDP
Enable or disable LLDP-MED.
LLDP-MED enables the phone to advertise itself to devices that
use the discovery protocol.
OnOn
Off
LLDP-MED
Set a value that causes a delay for the switch to get to the
forwarding state before the phone sends out the first LLDP-MED
packet. For configuration of some switches, you might need to
increase this value to a higher value for LLDP-MED to work.
Configuring a delay can be important for networks that use the
Spanning Tree Protocol.
Default delay is 3 seconds.
3 secondsStartup delay
Enable or disable VLAN.
Permits you to enter a VLAN ID when you use VLAN without
CDP or LLDP. When you use a VLAN with CDP or LLDP, that
associated VLAN takes precedent over the VLAN ID you
manually entered.
OffOn
Off
VLAN
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
42
Cisco IP Phone Installation
Network Configuration Fields
To Next Page
Loading...
Need help?
General
