CHAPTER
1-1
Cisco ASR 901 Series Aggregation Services Router Hardware Installation Guide
OL-23778-01
1
Introduction
The Cisco ASR 901 Mobile Wireless Router is a cell site gateway platform specifically designed to
provide transport for both legacy TDM and Ethernet traffic over a single converged network. The
Cisco
ASR 901 router is used at the cell site as a part of a 2G, 3G, or 4G radio access network (RAN)
traffic.
This chapter includes the following sections:
• Hardware Description, page 1-1
• Power Supply, page 1-5
• System Specifications, page 1-7
• Router Interface Numbering, page 1-7
• Regulatory Compliance, page 1-8
Hardware Description
Contained in a standard shelf-rack enclosure, the Cisco ASR 901 router weighs approximately 10
pounds (4 kg). It measures 1.7 inches high x 17.4 inches wide x 8.25 inches deep (4.32 cm or 1RU x 44.2
cm x 21.0
cm). These dimensions do not include the rack-mount brackets.
You can mount the router in a standard (ETSI) 19-inch (48.3 cm) equipment rack or 600mm ETSI rack
or a 23" ETSI rack.
The Cisco ASR 901 router includes the following hardware features:
• 16 T1/E1 RJ45 ports
• Four ports of 100/1000 Copper Ethernet including auto-MDIX (RJ45 connector)
• Four ports of SFP only
• Four combo ports (SFP/Copper)
• Dual feed supply with redundant DC inputs plus built in redundant power supply (RPS)
• Two fans placed in the chassis (fans are redundant)
• Chassis: 1RU, 8.25 inch depth
• Operating temperature range is -40 to +149°F (-40°C to +65°C).
• Side to side airflow
• Four solid state alarm inputs
• A single built-in 1GB Meninx Flash memory
To Next Page
Loading...
