Cisco Aironet 1300 Series - Page 13

13
Quick Start Guide Cisco Aironet 1300 Series Access Point
4. Enter the bridge password (default Cisco) in the Password field and press
Enter. The Summary Status page appears.
5. Click System Software and the System Software window appears.
6. Click System Configuration and the System Configuration window
appears.
7. Click Reset to Defaults. A warning appears prompting you to turn off
any popup blocking software on your system.
8. Click OK. The system restarts.
Note If the bridge is configured with a static IP address, the IP
address does not change.
9. After the bridge reboots, you can reconfigure the bridge by using the
Web-browser interface or the CLI (refer to the Cisco IOS Software
Configuration Guide for Cisco Aironet Bridges or to the Cisco IOS
Software Configuration Guide for Cisco Aironet Access Points).