Cisco Aironet AIR-AP1200 - Page 148

D-12
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-05
Appendix D Channels and Antenna Settings
Maximum Power Levels and Antenna Gains
Caution To avoid exceeding maximum conducted power levels in the EMEA (-E) and Singapore (–S) regulatory
domains when using an external antenna, you must manually set the access point output power level as
shown in Table D-11.
Note For the latest EMEA (-E) regulatory domain information, refer to the EU Directive 1999/5/EC
Compliance Information document that ships with this product.
.
Table D-11 RM22A Radio Module Maximum Power with External Antennas in the (–E) and (–S) Regulatory Domains
Channel
Identifier
Center Freq
(MHz)
Maximum Power Levels (dBm)
4-dBi-Antenna 4.5-dBi Antenna 6-dBi Antenna 7-dBi Antenna 9.5-dBi Antenna
5150 to 5250 MHz
34 5170 –––––
36 5180 17 17 15 15 11
38 5190 –––––
40 5200 17 17 15 15 11
42 5210 –––––
44 5220 17 17 15 15 11
46 5230 –––––
48 5240 17 17 15 15 11
5250 to 5350 MHz
1
1. Requires Cisco IOS Release 12.3(4)JA or later.
52 5260 17 17 15 15 11
56 5280 17 17 15 15 11
60 5300 17 17 15 15 11
64 5320 17 17 15 15 11
5470 to 5725 MHz
1
100 5500 17 17 17 17 17
104 5520 17 17 17 17 17
108 5540 17 17 17 17 17
112 5560 17 17 17 17 17
116 5580 17 17 17 17 17
120 5600 17 17 17 17 17
124 5620 17 17 17 17 17
128 5640 17 17 17 17 17
132 5660 17 17 17 17 17
136 5680 17 17 17 17 17
140 5700 17 17 17 17 17
5725 to 5850 MHz
149 5745 –––––
153 5765 –––––
157 5785 –––––
161 5805 –––––
165 5825 –––––