CHAPTER 2
Installation Preparation
• Installation Warnings, on page 21
• Safety Recommendations, on page 23
• Maintain Safety with Electricity, on page 23
• Prevent ESD Damage, on page 24
• Site Environment, on page 24
• Site Considerations, on page 24
• Power Supply Considerations, on page 25
• Rack Configuration Considerations, on page 25
Installation Warnings
Be sure to read the REGULATORY & COMPLIANCE SAFETY INFORMATION document before installing
the AMP PC3000 appliance.
Take note of the following warnings:
Statement 1071—Warning Definition
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
Statement 1005—Circuit Breaker
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: USA: 120 V, 15 A (EU: 250 V, 16 A)
Warning
Cisco AMP PC3000 Hardware Installation Guide
21
To Next Page
Loading...
