Specification
5.8 Bels (measure A-weighted per ISO7779 LWAd)
Operation at 73°F (23°C)
Sound power level
43 dBa (measure A-weighted per ISO7779 LpAM)
Operation at 73°F (23°C)
Sound pressure level
Product ID Numbers
The following table lists the spare Product IDs (PIDs) associated with the AMP PC3000. The spare components
are ones that you can order and replace yourself. If any internal components fail, you must RMA the entire
chassis including the SFPs and SFP cables. Remove the drives and power supplies before you send the chassis
for RMA. You can view an inventory of PIDs using the Cisco Integrated Management Interface (CIMC). See
Viewing Product ID (PID) Catalog Details for more information.
Table 4: AMP PC3000 PIDs
DescriptionPID
Power supplyAMPPC-AC-1050
Power supply (spare)AMPPC-AC-1050=
1.2-TB hard disk driveAMPPC-HDD-1.2TB
1.2-TB hard disk drive (spare)AMPPC-HDD-1.2TB=
1.8-TB hard disk driveAMPPC-HDD-1.8TB
1.8-TB hard disk drive (spare)AMPPC-HDD-1.8TB=
800-GB solid state driveAMPPC-SSD-800GB
800-GB solid state drive (spare)AMPPC-SSD-800GB=
Rail kitUCSC-RAILB-M4
Rail kit (spare)UCSC-RAILB-M4=
Power Cord Specifications
Each power supply has a separate power cord. Standard power cords or jumper power cords are available for
connection to the AMP PC3000. The jumper power cords for use in racks are available as an optional alternative
to the standard power cords.
If you do not order the optional power cord with the system, you are responsible for selecting the appropriate
power cord for the product. Using a incompatible power cord with this product may result in electrical safety
Cisco AMP PC3000 Hardware Installation Guide
12
Overview
Product ID Numbers
To Next Page
Loading...
