EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
13
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
Conditions: This issue occurs when show hw-module subslot 0 transceiver idprom command is
executed.
Workaround: There is no workaround.
• CSCui50862
Symptom: Few CFM primary sessions stays inactive.
Conditions: This issue occurs when CFM domain with SLA is configured.
Workaround: There is no workaround.
• CSCui87257
Symptom: The interface clock is not detected after a switchover
Conditions: This issue occurs after a switvchover is performed from RSP0 to RSP1.
Workaround: There is no workaround.
Resolved Caveats—Cisco IOS XE Release 3.7(4)S
This section documents the resolved caveats for the Cisco ASR 903 Router in Cisco IOS XE Release
3.7(4)S
• CSCtz43467
Symptom: All commands listed under the REP configuration modes cannot be configured. This
was seen while configuring REP with BDI and configuring more than one source ports in a span
session.
Conditions: This issue occurs in normal working conditions.
Workaround: There is no workaround.
• CSCua95675
Symptom: An Ethernet virtual circuit (EVC) interface stops forwarding traffic.
Conditions: This issue occurs when multiple EVCs are configured on a single interface. The EVCs
have the same outer tag VLAN.When one of the EVCs is removed from the configuration, the other
EVCs with the same outer tag VLAN stop passing traffic.
Workaround: Issue a shutdown command followed by a no shutdown command on the Ethernet
interface.
• CSCuc60148
Symptom: System does not shut down when the temperature sensor reaches shutdown threshold
region.
Conditions: This issue occurs when the temperature sensors reaches the shutdown threshold
region.
Workaround: Configure the facility-alarm critical exceed-action shutdown command has to
enable this system shutdown behavior.
• CSCud61551
Symptom: Serial Number of the RSP in slot 1 is not displayed some times in the show inventory
command output.
Conditions: This issue occurs under normal working conditions.
Workaround: Reload the router again.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals