EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
15
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
• CSCue25349
Symptom: Tracebacks seen on the router with inject bypass set to OFF.
Conditions: This issue occurs after shutting down the core facing interface or any OSPF enabled
interface.
Workaround: There is no workaround.These traces does not have any functional impact.
• CSCue51682
Symptom: The REP protocol flaps, as indicated by the following error messages:
*Feb 8 06:51:38.857: %REP-4-LINKSTATUS: GigabitEthernet0/0/1 (segment 10) is
non-operational due to neighbor not responding *Feb 8 06:51:39.096: %REP-4-LINKSTATUS:
GigabitEthernet0/0/1 (segment 10) is operational
Conditions: This issue occurs under the following conditions:
–
The router is sending traffic using the incremental MAC address table Fast LSL is configured
using a 200ms timer.
–
The router is configured with more than 2000 MAC addresses.
Workaround: Remove fast LSL from the REP configuration.
• CSCue60699
Symptom: The router auto-negotiates full duplex with 1000M half/full duplex configuration.
Conditions: This issue occurs when the router has Copper SFP with auto-negotiate enabled. and
SFP is configured with 1000M half-duplex mode.
Workaround: There is no workaround.
• CSCue61803
Symptom: The interface modules do not get powered off, when router is reloaded.
Conditions: This issue is occasionally seen on reload.
Workaround: There is no workaround.
• CSCue61850
Symptom: Memory allocation observed fro CFM EVC BD offload cases- scale configurations
Conditions: This issue occurs with CFM EVC BD, when 256 session of3.3ms interval and 256
SLM session are configured and a shutdown command followed by a no shutdown command is
issued on the traffic sending interface.
Workaround: Configure CFM session between 50-100.
• CSCue67835
Symptom: OSPF flap with aggressive timers (2 sec hello interval, 6 sec dead interval).
Conditions: This issue occurs on router Stateful switchover (SSO).
Workaround: Use the default OSPF hello timers.
• CSCue75372
Symptom: Time-hog traceback seen on router reload or IM reload.
Conditions: This issue occurs on router bootup or IM bootup.
Workaround: There is no workaround.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals