17
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
• CSCuf53527
Symptom: Cos inner value gets copied into the cos value.
Conditions: This issue occurs when QinQ without rewrite service instance is configured.
Workaround: Apply the qos policy-map to the cos inner value.
• CSCuf56723
Symptom: The interface LED glows green when shut.
Conditions: This issue occurs after an SSO is performed.
Workaround: There is no workaround.
• CSCuf65301
Symptom: Micro flaps observed on the router.
Conditions: This issue is seen when system is kept idle for hours.
Workaround: There is no workaround
• CSCuf79397
Symptom: F1 is stuck in init state after the standby RSP reloads.
Conditions: This issue occurs on a reload or OIR of the standby RSP.
Workaround: Reload the standby RSP again.
• CSCuf83886
Symptom: Label exhaust message is seen even on valid case if policy is configured before xconnect
is configured on scaled configuration.
Conditions: This issue occurs when a service-policy is configured before configuring xconnect on
the router that has consumed close to max labels.
Workaround: First configure xconnect and then configure service-policy.
• CSCug05239
Symptom: Traffic drops on the router.
Conditions: This issue occurs when configuring multichassis Link Aggregation Control Protocol
(MLACP) switchover with Ethernet over Multiprotocol Label Switching (EOMPLS).
Workaround: Configure port channel with EOMPLS.
• CSCug05647
Symptom: Interface counters do not get updated with IP traffic.
Conditions: This issue occurs when pinging back to back connected interfaces; the interface
counters stay at 0.
Workaround: Reload the device
• CSCug18630
Symptom: When you perform an OIR on the standby and active RSPs, CMAND crashes.
Conditions: This issue is observed after performing multiple standby OIRs and bringing the
standby machine up.
Workaround: There is no workaround.
To Next Page
Loading...
Need help?
General
