EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
26
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
• CSCty74115
Symptoms: The router displays traceback and CPU error messages.
Conditions: Occurs when you configure a high number of MAC address table entries while REP is
enabled; the router displays errors during a REP topology change, REP preemption, or when you
perform a shutdown/no shutdown on an interface.
Workaround: Reduce the number of MAC address entries.
• CSCua15499
Symptoms: The show interface command output displays 1000 Mbps information for both
100Mbps and 10 gigabyte transceivers.
Conditions: Occurs when you use 100 Mbps and 10 Gigabit Ethernet transceivers
Workaround: There is no workaround.
• CSCua25779
Symptom: An Ethernet virtual circuit (EVC) interface does not forward IPv4 traffic.
Conditions: Occurs when you apply the encapsulation dot1q command to an EVC, followed by
the encapsulation untagged command.
Workaround: Issue a shutdown/no shutdown on the EVC interface.
• CSCua62305
Symptom: QoS does not function on the router.
Conditions: Occurs under the following conditions:
–
You apply a service-policy and an ACL to the same interface
–
You modify the ACL by adding an ACE containing a permit ospf statement.
Workaround: There is no workaround.
• CSCub64331
Symptom: The 10Mhz reference clock to the SDH Equipment Timing Source (SETS) goes to
out-of-resource (OOR).
Conditions: Occurs when you connect both 10Mhz and 1pps inputs.
Workaround: Connect only the 10Mhz interface.
• CSCub71932
Symptom: The OC-3 interface module (IM) crashes.
Conditions: Occurs when you boot the router with an OC-3 IM and there are is no configuration
applied to the IM. The issue occurs intermittently.
Workaround: There is no workaround; wait for the interface module to reset.
• CSCub89531
Symptom: Multicast statistics in the MFIB output can show NA/NA. This causes multicast traffic
to drop every 3 minutes once the 3 minute timer expires.
Conditions: Occurs after an stateful switchover (SSO).
Workaround: Issue another SSO or reload the router.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals