EasyManuals Logo

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
28
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
–
The router is configured with a high number of serial interfaces
–
You reset an interface module or reload the router.
Workaround: There is no workaround.
• CSCuc91007
Symptom: A slave clock displays a high 1PPS offset value from the master clock.
Conditions: Occurs after an interface module reset or stateful switchover (SSO) on the master
device.
Workaround: There is no workaround.
• CSCuc95590
Symptom: The router does not automatically upgrade the FPGA software.
Conditions: Occurs when you load a new image while running an older FPGA version.
Workaround: There is no workaround; however the issue has no functional impact.
• CSCuc98185
Symptom: One out of 48 EFPs in a BDI does not receive traffic when running L3 multicast. The
issue does not happen consistently.
Conditions: Occurs under the following conditions:
–
You configure Protocol-Independent Multicast-Sparse Mode (PIM-SM) with a static
rendezvous point (RP).
–
You configure a bridge domain interface (BDI) on the PE2 access side
–
You use the BDI to send IGMP v2 static join messages to a single multicast group
–
You disable IGMP snooping globally.
–
You configure 24 EFPs and map them to a single bridge-domain.
–
You initiate multicast traffic.
–
With multicast traffic enabled, you configure 24 EFPs and map them to the existing
bridge-domain.
One of the 48 EFPs does not receive traffic.
Workaround: Reload the router.
• CSCud01644
Symptom: The active forwarding processor (FP) is on the standby route switch processor (RSP).
Conditions: Occurs when you boot the two RSPs in quick succession and the FP on the standby RSP
becomes active before the FP on the active RSP.
Workaround: Reload the router.
• CSCud07236
Symptoms: The router displays console error messages when reloading.
Conditions: Occurs when you reload the router.
Workaround: There is no workaround; however, the messages have no impact on device.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals