EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #148 background imageLoading...
Page #148 background image
60
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
Conditions: Occurs when you boot the router running QoS configurations at a high scale,
particularly queues.
Workaround: There is no workaround.
CSCua12366
Symptoms: The IOMD process corresponding to OC3 IM (interface module) crashes.
Conditions: Occurs when you perform an IM OIR after the router has been passing traffic.
Workaround: There is no workaround; the IM recovers after the crash and resumes traffic.
CSCua16143
Symptoms: IPv6 BFD sessions drop after you perform an SSO.
Conditions: Occurs when you perform an SSO on the router while running an IPv6 BFD
configuration. The issue does not occur with an IPv4 BFD configuration.
Workaround: After SSO, perform a shutdown/no shutdown on the physical interface.
CSCua16492
Symptoms: Some IPv6 multi-hop BFD over BGP sessions flap.
Conditions: Occurs on port-channel interfaces running IPv6 multi-hop BFD over BGP sessions
after you perform an SSO.
Workaround: There is no workaround.
CSCua25932
Symptoms: Convergence caused by an interface flap takes more than 50 milliseconds.
Conditions: Occurs when you enable BGP PIC core and LFA FRR at the same time.
Workaround: Use LFA FRR, as it converges in less than 50 milliseconds for BGP VPNv4 prefixes.
CSCua33453
Symptoms: A CFM configuration crashes after passing traffic for several hours.
Conditions: Occurs when you create the following configuration:
A port-channel interface configured with an EVC and applied to a bridge-domain
A physical interface configured as a trunk EFP
The offload sampling command is configured on both interfaces
Workaround: There is no workaround.
CSCua33788
Symptoms: The router does not pass multicast traffic consistently; only some traffic passes.
Conditions: Occurs when you configure 255 EVCs spanning across different slots on the router.
Workaround: There is no workaround.
CSCua36065
Symptoms: The router forwards multicast traffic on 63 out of 255 multicast output interfaces
(OIFs).
Conditions: Occurs when you configure the following:
255 EVCs on a single port mapped to 255 BDIs (one EVC per BDI) using rewrite tagging.
255 BDIs which send IGMP v2 Joins to a single multicast group.
255 EVCs configured as a routed port with the port a member link of a port-channel.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals