EasyManuals Logo

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
62
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.7S Releases
Conditions: Occurs when you configure multiple ATM IMA interfaces with fewer than 16 links per
bundle.
Workaround: Perform a hard OIR on the interface module.
CSCua56761
Symptoms: Gigabit Ethernet port 0/5/1 does not timestamp Ethernet OAM Y.1731 packets.
Conditions: Occurs when you configure Ethernet OAM on port 0/5/1 of a copper or SFP Gigabit
Ethernet interface module.
Workaround: There is no workaround.
CSCua61909
Symptoms: Changes to the police QoS command do not take effect.
Conditions: Occurs under the following conditions:
You create a QoS policy with a policer and attach the policy to an interface.
You make a dynamic change to the police action such as altering the policer value,
conform-action value, or exceed-action value.
Workaround: Remove the policy from the interface, make the necessary changes, and re-attach the
policy.
CSCua67795
Symptoms: The router does not transmit Y.1731 Delay Measurement Message (DMM) values using
QinQ encapsulation.
Conditions: Occurs with the following configuration:
An EFP is configured and applied to a bridge-domain.
The EFP is configured with QinQ encapsulation.
A Y.1731 Delay Measurement Message (DMM) value is applied.
The Y.1731 traffic uses a CoS value other than 0.
Workaround: There is no workaround.
CSCua70585
Symptoms: The router does not update Gigabit Ethernet interface bitmaps after you remove an EFP
from a multicast group. The router can display CPU hog messages.
Conditions: Occurs under the following conditions:
You create an EFP on a single bridge-domain interface (BDI)
The router receives IGMP v2 or v3 SSM Joins to the BDI
You create a second EFP on the same BDI
You delete the first or second EFP.
Workaround: There is no workaround.
CSCua72298
Symptoms: The router stops passing traffic on 10-15 HDLC interfaces.
Conditions: Occurs when you configure a large number of HDLC interfaces: 84 per port or 336 per
interface module.
Workaround: Remove and reconfigure the interface.
CSCua73104

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals