EasyManua.ls Logo

Cisco ASR 900 Series - Page 156

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Limitations and Restrictions
OC-3 IM Limitations
• The configure replace command is not supported on the OC-3 IMs.
• The optical interface module is designed for OC-3 and OC-12 traffic, but OC-12 functionality is not
currently supported.
• MPLS-TP is not supported over POS interfaces.
• Multicast is not supported on POS, MLPPP and OC-12 interfaces.
• MPLS is supported only on PoS and MLPPP interfaces; MPLS on T1/E1 links is not supported.
• IP-FRR and BFD-triggered FRR are not supported on MPLS over POS links.
• Fragmentation is not supported with Multicast traffic on PoS interfaces.
• QoS is not supported with Multicast traffic on PoS interfaces.
• QoS is supported on POS interfaces on optical interface module.
• Three-level QoS policies are not supported on OC-3/OC-12 serial, MLPPP, and PoS interfaces. You
can only apply QoS policies on two levels on these interfaces.
Pseudowire/AToM Limitation
• The Cisco ASR 903 Router supports ATM over MPLS N-to-one cell mode for a single ATM Virtual
Channel Connections (VCCs) or Permanent Virtual Circuits (PVCs) to a pseudowire, but does not
support mapping to multiple VCCs or PVCs.
• The Cisco ASR 903 Router does not support ATM over MPLS one-to-one cell mode.
• The Cisco ASR 903 Router supports pseudowire ping using the CW method; pseudowire ping using
the TTL method is not supported.
• The Cisco ASR 903 Router supports a maximum of 2000 pseudowires in any combination.
The following pseudowire (PW) features are supported over MPLS-TP connections:
• ATM over MPLS PWs
• ATM attachment circuits
• AAL5 Encapsulation
• ATM VC Class Support
• Cell Relay including VC mode, VP mode, and Packed Cell Relay
• CESoPSN
• L2VPN pseudowire redundancy
• Multi-segment PWs
• PW OAM/Status TLV Support
• PW Redundancy
• SAToP
The following pseudowire (PW) features are not supported over MPLS-TP connections:
• ATM OAM Cell Emulation for ATM AAL5 over MPLS on PVC and in VC Class.
• BFD / VCCV over ATM AC over MPLS TP
• BFD/ VCCV over TDM PW over MPLS TP Manageability
• Ethernet VLAN to Ethernet VLAN L2VPN interworking (bridged and routed modes)
• Ethernet VLAN to ATM AAL5 L2VPN Interworking (bridged and routed modes)

Table of Contents

Other manuals for Cisco ASR 900 Series

Related product manuals