11
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.8S Releases
Symptom: Multicast traffic is not bridged with REP.
Conditions: This issue occurs when multicast traffic flows on the REP configured interfaces.
Workaround: Unconfigure and configure REP on the interfaces.
• CSCuf61024
Symptom: TDM and OC-3 IM continuously crashes enters inserted state after ISSU is performed.
Conditions: This issue occurs after ISSU is performed.
Workaround: There is no workaround.
• CSCuf74113
Symptom: Interface mode cannot be entered for serial interfaces. Error messages are displayed.
Conditions: This issue occurs after creation of serial interfaces.
Workaround: There is no workaround.
• CSCuf80482
Symptom: Configuration synchronization fails from active to standby IOMD.
Conditions: This issue occurs on IM OIR.
Workaround: Perform a soft reset of the IM or the interface flap.
• CSCuf86247
Symptom: SNMP MIB variables related to BDI counters do not function properly.
Conditions: This issue occurs when you use SNMP MIB variables related to BDI interface counters.
Workaround: There is no workaround.
• CSCuf89725
Symptom: After IM OIR the remote MEP shows BLK state on CFM offload.
Conditions: This issue occurs when CFM MEP is configured an IM OIR is performed.
Workaround: There is no workaround.
• CSCug05491
Symptom: The router drops traffic on VPLS circuits.
Conditions: This issue occurs when the following is performed:
–
Configure REP with or without VLAN load balancing
–
Configure VPLS VFI on the VLANs
–
Issue an stateful switchover (SSO).
Workaround: There is no workaround.
• CSCug05647
Symptom: Interface counters do not get updated with IP traffic.
Conditions: This issue occurs when performing a back-to-back ping on the connected interfaces.
Workaround: Perform a router reload.
• CSCug39899
Symptom: Traffic stops flowing through QinQ BDI interface after ARP times out and ARP is
removed by shutting the BDI.
To Next Page
Loading...
Need help?
General
