13
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.8S Releases
• CSCud13242
Symptom: The Cisco ASR 903 router does not display an alarm when nV satellite authentication
fails.
Conditions: This issue occurs when the ASR 9000 and ASR 903 are in an nV satellite configuration
and the routers are configured with a different serial-number value.
Workaround: There is no workaround.
• CSCud26812
Symptom: The router CLI does not display some SFP PIDs.
Conditions: This issue occurs when you install one of the following SFPs in the router:
–ONS-SI-155-L2
–ONS-SI-155-L1
–ONS-SI-155-I1
Workaround: There is no workaround.
• CSCud29479
Symptom: The router stops applying QoS configurations.
Conditions: Occurs under the following conditions:
–An Ethernet interface is configured with a single service instance
–A QoS policy is attached to the service instance
–The QoS policy contains a single class containing a match EFP statement.
–You reset the interface to the default configuration.
Workaround: There is no workaround.
• CSCud30806
Symptom: The router accepts a QoS WRED configuration containing match-all configurations for
two different prec values, which is not supported.
Conditions: This issue occurs when you configure a policy with a class-map containing match-all
configurations for two different prec values.
Workaround: There is no workaround.
• CSCud34346
Symptom: The router crashes with multiple ECMP paths configured.
Conditions: The issue can occur when:
–The router is configured with multiple ECMP paths.
–MPLS IP is not enabled on one of the ECMP paths.
Workaround: There is no workaround.
• CSCud38038
Symptom: The router records incorrect delay measurements after a reload.
Conditions: This issue occurs under the following conditions:
–You configure Delay Measurement Message (DMM) on a port-channel interface.
–The port-channel member links are on different interface modules (IMs).
–You reload the router.
To Next Page
Loading...
Need help?
General
