EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
22
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.8S Releases
–
A QoS policy is attached to the service instance
–
The QoS policy contains a single class containing a match efp statement.
–
You reset the interface to the default configuration.
Workaround: There is no workaround.
• CSCud33906
Symptom: Equal Cost Multipath (ECMP) loopback does not function properly.
Conditions: Occurs when a port-channel link dynamically assigned as an ECMP path.
Workaround: There is no workaround.
• CSCud56262
Symptom: The router stops passing traffic on virtual circuits.
Conditions: Occurs an MPLS-TE/FRR configuration with L2VPN after you issue a stateful
switchover (SSO).
Workaround: Reload the router.
• CSCud64436
Symptom: The router does not send the full line rate on POS interfaces.
Conditions: Occurs when you send traffic over a POS interface on the OC-3 interface module with
a QoS configuration.
Workaround: There is no workaround.
• CSCud89451
Symptom: The router crashes with an error message showing nmpls_label_populate_flow_data.
Conditions: Occurs when you reset a core interface while the ASR 903 is acting as a PE router and
running a configuration with L2VPN and L3VPN.
Workaround: There is no workaround.
• CSCud95359
Symptom: The show policy map command displays an incorrect number of total dropped packets
(total drops).
Conditions: Occurs when you issue the show policy-map command to display dropped packets on
an interface.
Workaround: There is no workaround.
• CSCue01419
Symptom: The router loses EIGRP neighborship.
Conditions: Occurs on OC-3 and OC-12 interface configured on port 0.
Workaround: Issue a shutdown/no shutdown on interfaces configured on port 0. You can also
remove and reconfigure EIGRP.
• CSCue43205
Symptom: The router drops traffic when you set an interface to the default configuration.
Conditions: Occurs when you set an interface with QoS configurations to the default configuration.
The issue occurs most often with the Ten Gigabit Ethernet interface using a full global configuration.
Workaround: There is no workaround.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals