EasyManuals Logo

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #231 background imageLoading...
Page #231 background image
35
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Caveats in Cisco IOS XE 3.9S Releases
Conditions: When IMA are configured.
Workaround: OIR.
• CSCub33664
Symptoms: High Delay values seen when using DMM Sesssion on ASR903 post SSO.
Conditions: Delay values will be higher only after SSO on ASR903.
Workaround: Remove and reconfigure DMM sessions again post SSO on AR903.
• CSCub38619
Symptoms: System crashes when COS value for vlan under an EFP is modified.
Conditions: This happens only when a prior operator attempt to modify the COS value failed. This
failure can be due to incompatible efp match conditions on the egress efp.
Workaround: None
• CSCub41772
Symptom: Router console is flooded with CPUHOG and EVENTLIB messages.
Conditions: The issue occurs rarely when you issue multiple interface module reset (OIRs), RSP
switchovers (SSO), or reloads while using a configuration with a high number of T1 serial links on
the OC-3 interface module.
Workaround: There is no workaround; however, the messages to not affect router functionality.
• CSCub48129
Symptoms: CFM CCM’s were being sent out on egress interface with cfm disabled.
Conditions: Configure UP mep on EVC BD.DIsable cfm on the egress interface.
Workaround: There is no workaround.
• CSCub49985
Symptoms: MPLS pseudowire ping from the peer to the Cisco ASR 903 fails if the peer is using
TTL-based ping.
Conditions: This symptom occurs when the peer is using TTL-based ping.
Workaround: There is no workaround.
• CSCub50110
Symptoms: Tx timer table not programmed after shut/no shut for hardware offload BFD. It is not
consistently seen.
Conditions: The issue is seen while we do shut/no shut on BDI/Physical interface which has BFD
configured.
Workaround: None.
• CSCub50487
Symptoms: The router accepts a rewrite push statement on an EFP configured with QinQ
encapsulation.
Conditions: Occurs when you configure an xconnect EFP with QinQ encapsulation and a rewrite
push statement.
Workaround: There is no workaround.
• CSCub52571
Symptoms: Traceback seen on console. This traceback doesn’t impact any functionality

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals