Cisco ASR 900 Series Release Notes

7
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.10S Releases
• CSCuj43453
Symptom: IOSd crash was seen on the router on bootup of PTP process.
Conditions: This issue occurs during bootup when multiple reloads of the router is performed.
Workaround: There is no workaround.
• CSCuj43795
Symptom: The port in error-disabled state & physical status shows as down but is UP on the other
connected end device.
Conditions: This issue occurs when the port is configured with DHCP rate limiting values so that
the port goes to error-disable state once it reaches the rate configured.
Workaround: Perform a shutdown followed by a no shutdown on the respective interface to move
the port to UP state.
• CSCuj60116
Symptom: SYNC-E does not get synced in WAN mode.
Conditions: This issue occurs in WAN mode.
Workaround: There is no workaround.
• CSCuj60771
Symptom: Self-generated DHCP traffic generating out of the router is not getting marked (cos) with
user specified value.
Conditions: This issue occurs when DHCP packets (CPU to client) are not getting marked.
Workaround: There is no workaround.
• CSCuj96689
Symptom: Queue-limit command is not programmed for priority queue.
Conditions: This issue occurs when the policy map has both BRP and Priority queue with
queue-limit configured for priority queue.
Workaround: Perform the following;
– Attach the policy with all BRP configuration.
– Dynamically add the queue-limit command to the priority class.
• CSCul10279
Symptom: Crash observed on the router with multicast VPN configuration.
Conditions: This issue occurs when the router is configured with multicast VPN IPv4 configuration,
Scaled ACL and IGMP Static Join configuration.
Workaround: There is no workaround.
• CSCul11877
Symptom: HSRP standby router cannot ping the virtual IP.
Conditions: This issue occurs when the BDI interfaces are configured along with a range of bridge
domains.
Workaround: There is no workaround.
• CSCul21294
Symptom: PTSF alarms do not get posted when the egress interface is shutdown.
Conditions: This issue occurs when a PTP slave has one or more masters.

Cisco ASR 900 Series Specifications

General

Brand	Cisco
Model	ASR 900 Series
Category	Network Router
Language	English