EasyManuals Logo
Home>Cisco>Network Router>ASR 900 Series

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #268 background imageLoading...
Page #268 background image
14
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.10S Releases
Symptom: The system shuts down after 5mins irrespective of ambient temperature after removing
the fan tray.
Conditions: This issue occurs after removing the fan tray.
Workaround: There is no workaround.
CSCuh81135
Symptom: Port speed configuration is changed automatically on changing the SFP module.
Conditions: This issue occurs on changing the SFP module.
Workaround: There is no workaround.
CSCuh85990
Symptom: Some CFM MEPs are not learnt when configuring large number (about 1K) on the router.
Conditions: This issue is seen only if large number of MEPs are configured.
Workaround: Remove and re-apply the configuration.
CSCuh92939
Symptom: Traffic drop occurs after replacing a Cu SFP with a fiber FP
Conditions: This issue occurs after replacing Cu SFP with fiber SFP after an SSO is performed.
Workaround: Perform an IM OIR.
CSCuh99117
Symptom: Packet drops for some of the prefixes in MPLS network are observed.
Conditions: This issue occurs when MPLS Layer3 VPN is configured on the router with MVPN
template.
Workaround: There is no workaround.
CSCui16418
Symptom: After a switchover is performed, the ten gigabit ethernet interface might flap and traffic
drops.
Conditions: This issue occurs after SSO is performed.
Workaround: There is no workaround.
CSCui32127
Symptom: CFM download error-objects are observed when CFM peers are reloaded or IM OIR is
done on a scaled VPLS and CFM setup.
Conditions: This issue occurs on the router with 250 or more CFM MEP sessions and more than
1250 Layer2 virtual circuit sessions.
Workaround: There is no workaround.
CSCui34041
Symptom: Traffic does not flow to one of the prefix on MPLS template.
Conditions: This issue occurs when maximum MPLS label of that template is assigned to that
prefix.
Workaround: Disable and enable the prefix.
CSCui40994
Symptom: Ethernet CFM ping fails because remote MEPs are not learnt.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals