EasyManuals Logo

Cisco ASR 900 Series Release Notes

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #281 background imageLoading...
Page #281 background image
27
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.10S Releases
• CSCue57671
Symptom: Router crashes while running the REP configuration.
Conditions: This issue is observed while removing the REP configuration from the interface.
Workaround: There is no workaround.
• CSCue66019
Symptom: The router displays MLPPP interface errors.
Conditions: This issue is observed when there is more than 90% line rate traffic with mix MTU
patterns.
Workaround: There is no workaround.
• CSCue67835
Symptom: OSPF flaps when you set the dead interval timer as 6 seconds and hello interval as 2
seconds.
Conditions: This issue is observed when you perform an SSO.
Workaround: Use the default OSPF hello timers.
• CSCue72481
Symptom: The same interface accepts an IP address and a MEP.
Conditions: This issue is observed when you configure an IP address and a MEP to the same
interface.
Workaround: There is no workaround.
• CSCue83621
Symptom: Policy map stops working after you dynamically remove class default class.
Conditions: This issue is observed when the policy map is attached to the target and the class default
of the top level is deleted dynamically, the policy stops working.
Workaround: Detach and reattach the policy map on the target.
• CSCue89503
Symptom: The power supply status reports critical after you remove and insert the power supply.
Conditions: This issue is observed after performing multiple OIRs.
Workaround: There is no workaround.
• CSCuf01120
Symptom: IOMD crash is seen while performing an SSO when card type is not configured for T1E1
IM.
Conditions: This issue is observed when the TDM card type is not configured before performing an
SSO.
Workaround: Configure the card type for T1E1 IM before preforming an SSO.
• CSCuf20151
Symptom: The following error message is displayed when you apply a policy map:
QoS: Configuration failed. Can NOT match ACL in an output policy-map
Conditions: This issue is observed when you apply a policy map, reload, or reconfigure of the
policy map.

Table of Contents

Other manuals for Cisco ASR 900 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 900 Series and is the answer not in the manual?

Cisco ASR 900 Series Specifications

General IconGeneral
BrandCisco
ModelASR 900 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals