EasyManua.ls Logo

Cisco ASR 900 Series - Page 303

Cisco ASR 900 Series
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
OL-26630-12
Chapter
Caveats in Cisco IOS XE 3.12S Releases
Conditions: This issue occurs when the host queue is congested by ICMP punt traffic for a long
time.
Workaround: There is no workaround.
• CSCul27129
Symptom: Remote MEPs are not learnt on cross-connect service with a POS interfaces the core
link.
Conditions: This issue occurs when CFM up MEPs are configured for an cross-connect service
configured on an access interface, with POS links in core.
Workaround: There is no workaround.
• CSCul37563
Symptom: Packet drop observed after resetting the multilink bundle more than 3 or 4 times.
Conditions: This issue occurs on an MLPPP interface over channelized STM.
Workaround: Configure the remote end to accept compressed packets.
• CSCul40676
Symptom: Ping failure observed on the interface connected with port 0/0/0 with ACR configuration.
Conditions: This issue occurs when ACR is configured on the router.
Workaround: Install the IM in the other bay or use a port other than 0/0/0 as the core.
• CSCul64840
Symptom: The router shuts down when the SNMP host is enabled by executing the snmp-server
host command globally.
Conditions: This issue occurs when the snmp-server host command is executed.
Workaround: Use the management interface VRF for the SNMP host.
• CSCul68008
Symptom: Bulk synchronization fails for ATM layer 2 configuration on T1E1 IM is observed on
the router.
Conditions: This issue occurs on TDM IM with ATM configuration.
Workaround: There is no workaround.
• CSCul93778
Symptom: No alarm is reported after executing the shutdown command on the controller, when
high availability (HA) is setup.
Conditions: This issue occurs when a POS interface is created on an HA setup, and a shutdown
command is executed on the interface after SSO.
Workaround: There is no workaround.
• CSCum66060
Symptom: Increased usage of MPLSintd observed after scale configuration and stress test. Interface
flaps and BFD flaps are observed on the router.
Conditions: This issue occurs with increased usage in MPLSintd resource leading to router crash
over a prolong period of time.
Workaround: There is no workaround.

Table of Contents

Other manuals for Cisco ASR 900 Series

Related product manuals