Cisco ASR 9000v User Manual

Figure 109: Removing a Line Card from the Cisco ASR 9912 Router Top Card Cage
Slide the card out of
the chassis.
3Pivot the ejector
levers outward to
unseat the card from
the backplane
connector.
2Loosen the captive
screws.
1
Step 4 Repeat Step 2 or Step 3 for each FC, LC, and RP card.
Rack-Mounting the Router Chassis
The router chassis is installed in a front-mounted position, as shown in the Telco 2-Post Rack section.
In a front-mounted position, the chassis rack-mounting flanges are secured directly to the rack posts.
The Cisco ASR 9922 Router and Cisco ASR 9912 Router are designed to mount in only 4-post racks.
Note
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
102
Unpacking and Installing the Chassis
Rack-Mounting the Router Chassis

Cisco ASR 9000v Specifications

General

Chassis Type	Virtual
Operating System	Cisco IOS XR
Form Factor	Virtual Appliance
Type	Virtual Router
License Required	Yes
Supported Platforms	VMware ESXi, KVM, Microsoft Hyper-V
Interfaces	Virtual Ethernet
High Availability	Yes
Management	CLI, NETCONF
Protocols	BGP, OSPF, IS-IS, MPLS, IPv4, IPv6
Product Family	Cisco ASR 9000 Series
Encryption Support	Yes