Cisco ASR 9000v User Manual

Figure 212: Removing or Installing a Version 2 or Version 3 AC or DC Power Module
Figure 213: Removing or Installing a Version 2 AC or DC Power Module from the Cisco ASR 9904 Router
Installing a Version 1 AC or DC Power Module
Follow these steps to install a new version 1 AC or DC power module (Figure 211: Removing or Installing
a Version 1 AC or DC Power Module, on page 235):
Procedure
Step 1 Slide the power module into the bay until it mates with its backplane connector.
Step 2 Pivot the door to the left until the door latch locks.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
236
Replacing Cisco ASR 9000 Series Router Components
Installing a Version 1 AC or DC Power Module

Cisco ASR 9000v Specifications

General

Chassis Type	Virtual
Operating System	Cisco IOS XR
Form Factor	Virtual Appliance
Type	Virtual Router
License Required	Yes
Supported Platforms	VMware ESXi, KVM, Microsoft Hyper-V
Interfaces	Virtual Ethernet
High Availability	Yes
Management	CLI, NETCONF
Protocols	BGP, OSPF, IS-IS, MPLS, IPv4, IPv6
Product Family	Cisco ASR 9000 Series
Encryption Support	Yes