Cisco ASR 9000v User Manual

Cisco ASR 9912 Clearance Requirements
To install the Cisco ASR 9912 Router in a 4-post enclosed cabinet:
• The front and rear doors of the cabinet must be removed or be perforated with a minimum open area of
70 percent open area (80 percent for 800-mm racks)
.
• Ensure that you have the following clearances around the chassis:
• Rear: Minimum of 10 inches (25.4 cm) of clearance.
• Sides: Minimum of 2.87 inches (7.28 cm) of clearance on each side of the chassis.
This figure shows the side and rear chassis air-flow clearance requirements for mounting the router in a 4-post
enclosed rack.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
24
Preparing for Installation
Cisco ASR 9912 Clearance Requirements

Cisco ASR 9000v Specifications

General

Chassis Type	Virtual
Operating System	Cisco IOS XR
Form Factor	Virtual Appliance
Type	Virtual Router
License Required	Yes
Supported Platforms	VMware ESXi, KVM, Microsoft Hyper-V
Interfaces	Virtual Ethernet
High Availability	Yes
Management	CLI, NETCONF
Protocols	BGP, OSPF, IS-IS, MPLS, IPv4, IPv6
Product Family	Cisco ASR 9000 Series
Encryption Support	Yes