Cisco ASR 9000v User Manual

Figure 148: Attaching Plastic Glide Strip to Chassis
Step 3 Install the plenum in the rack. Insert and tighten four customer-supplied screws to secure the plenum to the
front of the rack-post (two on each side). These screws can vary in size and type depending on the rack that
you use. Torque the screws to the weight specified for your particular rack. See Figure 149: Plenum with
Pre-Installed Front Mounting Brackets, on page 141 and Figure 150: Installing the Plenum in a Two-Post
19-Inch Rack, on page 142.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
140
Unpacking and Installing the Chassis
Installing Optional Air Baffles on the Cisco ASR 9006 Router

Cisco ASR 9000v Specifications

General

Chassis Type	Virtual
Operating System	Cisco IOS XR
Form Factor	Virtual Appliance
Type	Virtual Router
License Required	Yes
Supported Platforms	VMware ESXi, KVM, Microsoft Hyper-V
Interfaces	Virtual Ethernet
High Availability	Yes
Management	CLI, NETCONF
Protocols	BGP, OSPF, IS-IS, MPLS, IPv4, IPv6
Product Family	Cisco ASR 9000 Series
Encryption Support	Yes