Cisco ASR 9001 Installation Guide

Procedure
Step 1 Remove any strapping on the outside of the crate.
Step 2 Remove the crate cap door. Disengage the twist locks located along the bottom first. Then, disengage the twist
locks located along the sides, working your way up from the bottom to the top. Refer to the right and middle
figures in Figure 73: Unpacking the Cisco ASR 9922 Router from the Shipping Container, on page 69.
Step 3 Remove the crate cap. Disengage the twist locks located around the bottom of the crate cap (Figure 73:
Unpacking the Cisco ASR 9922 Router from the Shipping Container, on page 69).
Two people are required to evenly slide the crate cap back off of the plastic pallet base.
Note
Step 4 Remove the foam packaging material from the top of the router.
Figure 73: Unpacking the Cisco ASR 9922 Router from the Shipping Container
Step 5 Using a 5/16” wrench or ratchet, remove the four attachment bolts and cross-brace from the shipping rack
(see the figure below).
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
69
Unpacking and Installing the Chassis
Unpacking the Cisco ASR 9922 Router

Cisco ASR 9001 Specifications

General

Brand	Cisco
Model	ASR 9001
Category	Network Router
Language	English