Cisco ASR 903 - Page 100

MPLS TE Configuration
▀ Explicit Path by using Affinity
▄ Cisco ASR 903 Router Design and Deployment Guide
100
OL-30526-01
InLabel : -
OutLabel : GigabitEthernet0/1/1, 25
Next Hop : 10.10.13.3
RSVP Signalling Info:
Src 10.10.1.1, Dst 10.10.4.4, Tun_Id 12, Tun_Instance 14
RSVP Path Info:
My Address: 10.10.13.1
Explicit Route: 10.10.13.3 10.10.34.3 10.10.34.4 10.10.4.4
Record Route: NONE
Tspec: ave rate=500 kbits, burst=1000 bytes, peak rate=500 kbits
RSVP Resv Info:
Record Route: NONE
Fspec: ave rate=500 kbits, burst=1000 bytes, peak rate=500 kbits
Shortest Unconstrained Path Info:
Path Weight: 2 (TE)
Explicit Route: 10.10.13.1 10.10.13.3 10.10.34.3 10.10.34.4
10.10.4.4
History:
Tunnel:
Time since created: 11 hours, 23 minutes
Time since path change: 11 hours, 15 minutes
Number of LSP IDs (Tun_Instances) used: 14
Current LSP: [ID: 14]
Uptime: 11 hours, 15 minutes
Prior LSP: [ID: 1]
ID: path option unknown
Removal Trigger: configuration changed
Creating Tunnel13 using Blue Path
ASR903-R1 Configuration
interface Tunnel13
ip unnumbered Loopback10
tunnel source Loopback10
tunnel mode mpls traffic-eng
tunnel destination 10.10.4.4
tunnel mpls traffic-eng priority 3 3
tunnel mpls traffic-eng bandwidth 500
tunnel mpls traffic-eng affinity 0x2 mask 0x2
tunnel mpls traffic-eng path-option 3 dynamic
interface GigabitEthernet0/1/0
mpls traffic-eng attribute-flags 0x2
ASR903-R2 Configuration
interface GigabitEthernet0/1/0
mpls traffic-eng attribute-flags 0x2
!
interface GigabitEthernet0/1/2
mpls traffic-eng attribute-flags 0x2