Cisco ASR 903 Guide

MPLS TE Configuration
BFD Triggered TE Fast Reroute ▀
Cisco ASR 903 Router Design and Deployment Guide▄
OL-30526-01
103
BFD Triggered TE Fast Reroute
ASR903-R1 Configuration
interface GigabitEthernet0/1/1
ip address 10.10.34.3 255.255.255.248
negotiation auto
mpls ip
mpls traffic-eng tunnels
mpls traffic-eng attribute-flags 0x1
bfd interval 50 min_rx 50 multiplier 3
ip rsvp bandwidth 40000
ip rsvp signalling hello bfd
ASR903-R3 Configuration
interface GigabitEthernet0/1/0
ip address 10.10.13.3 255.255.255.248
ip ospf dead-interval 3
ip ospf hello-interval 1
negotiation auto
mpls ip
mpls traffic-eng tunnels
mpls traffic-eng attribute-flags 0x1
bfd interval 50 min_rx 50 multiplier 3
ip rsvp bandwidth 40000
ip rsvp signalling hello bfd
!
interface GigabitEthernet0/1/1
ip address 10.10.34.3 255.255.255.248
negotiation auto
mpls ip
mpls traffic-eng tunnels
mpls traffic-eng attribute-flags 0x1
bfd interval 50 min_rx 50 multiplier 3
ip rsvp bandwidth 40000
ip rsvp signalling hello bfd

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1