Cisco ASR 903 - ISSU Procedure; Appendix A References

Cisco ASR 903 Software Upgrade
ISSU One Shot Upgrade Overview ▀
Cisco ASR 903 Router Design and Deployment Guide▄
OL-30526-01
147
universal.03.08.01.S.153-1.S1.conf
25194852 Apr 18 2013 16:01:01 +00:00 asr903rsp1-rpaccess.03.08.01.S.153-1.S1.pkg
34224484 Apr 18 2013 16:01:08 +00:00 asr903rsp1-rpbase.03.08.01.S.153-1.S1.pkg
26745188 Apr 18 2013 16:01:15 +00:00 asr903rsp1-rpcontrol.03.08.01.S.153-1.S1.pkg
57137508 Apr 18 2013 16:01:31 +00:00 asr903rsp1-rpios-universal.03.08.01.S.153-
1.S1.pkg
25725284 Apr 18 2013 16:01:38 +00:00 asr903rsp1-sipbase.03.08.01.S.153-1.S1.pkg
24547684 Apr 18 2013 16:01:45 +00:00 asr903rsp1-sipspa.03.08.01.S.153-1.S1.pkg
The redundancy mode should be configured for SSO and the SSO state should be reached prior to starting the test.
Router# configure terminal
Router(config)# redundancy
Router(config)# mode ss0
Router(config)# end
*Jan 12 17:52:26.516: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)
ISSU Procedure
Step 1 Issue the request platform software package install command on the active RP.
Router# request platform software package install node file bootflash:/issu/
asr903rsp1-universal.03.09.00.S.153-2.S.bin interface-module-delay 150
Step 2 Wait for the successive stages to complete as indicated by STAGE and SUCCESS messages that are displayed on
the active RP console after each stage completes. In general interface-module-delay timer of 120-150 seconds is
recommended most of the cases to make sure that one IM can fully boot up before resetting next IM.
Step 3 Wait for the original active RP to reboot. This will occur after the completion of STAGE 5.
Step 4 Connect to the new active console wait for the redundancy state to return to SSO state.
Appendix A References
ASR 903 Web site:
http://www.cisco.com/en/US/products/ps11610/index.html