Cisco ASR 903 Guide

BGP PIC & RFC3107
Configuration for BGP PIC (with OSPF) ▀
Cisco ASR 903 Router Design and Deployment Guide▄
OL-30526-01
121
172.16.2.2 nolabel/30
ASR903-R1# ping 172.16.4.4 source 172.16.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.4.4, timeout is 2 seconds:
Packet sent with a source address of 172.16.1.1
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/2 ms
ASR903-R1# show ip route
Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route, H - NHRP, l - LISP
a - application route
+ - replicated route, % - next hop override
Gateway of last resort is not set
1.0.0.0/32 is subnetted, 1 subnets
C 172.16.1.1 is directly connected, Loopback0
2.0.0.0/32 is subnetted, 1 subnets
O 172.16.2.2 [110/2] via 10.10.1.2, 1w0d, GigabitEthernet0/2/0
3.0.0.0/32 is subnetted, 1 subnets
O 172.16.3.3 [110/2] via 10.10.2.2, 2d21h, GigabitEthernet0/2/2
4.0.0.0/32 is subnetted, 1 subnets
B 172.16.4.4 [200/0] via 172.16.2.2, 1d20h
10.0.0.0/8 is variably subnetted, 6 subnets, 2 masks
C 10.10.1.0/24 is directly connected, GigabitEthernet0/2/0
L 10.10.1.1/32 is directly connected, GigabitEthernet0/2/0
C 10.10.2.0/24 is directly connected, GigabitEthernet0/2/2
L 10.10.2.1/32 is directly connected, GigabitEthernet0/2/2
O 10.10.3.0/24 [110/2] via 10.10.2.2, 2d21h, GigabitEthernet0/2/2
[110/2] via 10.10.1.2, 2d21h, GigabitEthernet0/2/0
B 10.10.7.0/24 [200/0] via 172.16.2.2, 1d20h
ASR903-R1# show ip route 172.16.4.4
Routing entry for 172.16.4.4/32
Known via "bgp 100", distance 200, metric 0, type internal
Last update from 172.16.2.2 1d20h ago
Routing Descriptor Blocks:
* 172.16.2.2, from 172.16.2.2, 1d20h ago
Route metric is 0, traffic share count is 1
AS Hops 0
MPLS label: 28

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1