Cisco ASR 903 - Page 94

MPLS TE Configuration
▀ Basic Steps to Configure Traffic Engineering
▄ Cisco ASR 903 Router Design and Deployment Guide
94
OL-30526-01
ASR903-R1 Configuration
interface GigabitEthernet0/1/0
ip address 10.10.12.1 255.255.255.248
ip ospf dead-interval 3
ip ospf hello-interval 1
negotiation auto
mpls ip
mpls traffic-eng tunnels
ip rsvp bandwidth 30000
!
interface GigabitEthernet0/1/1
ip address 10.10.13.1 255.255.255.248
ip ospf dead-interval 3
ip ospf hello-interval 1
negotiation auto
mpls ip
mpls traffic-eng tunnels
ip rsvp bandwidth 40000
!
mpls label protocol ldp
mpls ldp explicit-null
mpls ldp session protection
mpls ldp igp sync holddown 200
mpls ldp discovery targeted-hello accept
mpls traffic-eng tunnels
mpls ldp router-id Loopback10 force
!
router ospf 100
router-id 10.10.1.1
timers throttle spf 5 50 200
timers throttle lsa 5 50 200
timers lsa arrival 10
timers pacing flood 5
network 10.10.1.1 0.0.0.0 area 0
network 10.10.12.1 0.0.0.0 area 0
network 10.10.13.1 0.0.0.0 area 0
mpls traffic-eng router-id Loopback10
mpls traffic-eng area 0
ASR903-R2 Configuration
interface GigabitEthernet0/1/2
ip address 10.10.24.2 255.255.255.248
ip ospf dead-interval 3
ip ospf hello-interval 1
negotiation auto
mpls ip
mpls traffic-eng tunnels
ip rsvp bandwidth 30000
!
interface GigabitEthernet0/1/0
ip address 10.10.12.2 255.255.255.248