Cisco ASR 903 Installing Guide

Tools and Equipment
•
Dual-hole lugs
•
Double barrel with inspection hole
•
Hole spacing is 5/8 in.
•
Lug tab width max 0.46 in.
•
Nuts
• PSU can accommodate 10 – 6 AWG
•
Number 2 Phillips Screwdriver
Perform the following procedure to install the terminal block.
Step 1
Locate the terminal block on the power supply unit.
Step 2
Flap open the front protective cover on the power supply unit.
Step 3
Use a wire-stripping tool to strip the ends of each of the two wires coming from the DC-input power source as
recommended by the lug manufacturer.
Stripping more than the recommended amount of wire can leave behind exposed wire from the terminal block
after installation.
Note
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
35
Installing the Cisco ASR 903 Router
Installing the DC Power Supply

Cisco ASR 903 Specifications

General

Brand	Cisco
Model	ASR 903
Category	Network Router
Language	English