4-9
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
Chapter 4 Initial Configuration
Configuring the Router at Startup
Step 4 At the password prompt, enter your system password, as shown in the following example. If an enable
password has not been set on your system, you can skip this step.
Password: enablepass
When your password is accepted, the privileged EXEC mode prompt is displayed:
Router#
You now have access to the CLI in the privileged EXEC mode. You can enter the necessary commands
to complete the required tasks.
Step 5 To exit the console session, enter the quit command, as shown in the following example:
Router# quit
Configuring Global Parameters
When you first start the setup program, configure the global parameters. These parameters are used for
controlling system-wide settings. Perform the following steps to enter the global parameters:
Step 1 Connect a console terminal to the console port, and then boot the router. For more information on
connecting a console terminal, see Connecting Console Cables section.
Note The following is only an example of the output display; prompts may vary.
When you see this information, it means that you have successfully booted your router:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2 The first sections of the configuration script appear only at an initial system startup. On subsequent uses
of the setup facility, the script begins with a System Configuration Dialog as shown below: When you
are prompted about whether you want to enter the initial configuration dialog, enter yes.
Would you like to enter the initial configuration dialog? [yes/no] yes
To Next Page
Loading...
Need help?
General
