Cisco C9200L-24T-4X User Manual

It may take up to three mins. You must complete the Day0 setup through the WebUI before using the device
terminal.
Step 4 Launch a Web browser on the PC and enter the device IP address (https://192.168.1.1) in the address
bar.
What to do next
Create a user account.
Creating User Accounts
Setting a username and password is the first task you will perform on your device. Typically, as a network
administrator, you will want to control access to your device and prevent unauthorized users from seeing your
network configuration or manipulating your settings.
Procedure
Step 1 Log on using the default username and password provided with the device.
The default username is cisco; the default password is the serial number of the switch chassis. For Cisco
Catalyst switches running software versions earlier than Cisco IOS XE Fuji 16.9.x, the default username is
webui; the default password is the serial number of the switch chassis.
Step 2 Set a password of up to 25 alphanumeric characters. The username password combination you set gives you
privilege 15 access. The string cannot start with a number, is case sensitive, and allows spaces but ignores
leading spaces.
Figure 34: Create Account
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
52
Configuring the Switch
Creating User Accounts

Cisco C9200L-24T-4X Specifications

General

Model	C9200L-24T-4X
Device Type	Switch
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
DRAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Ports	24 x 10/100/1000
Uplink Interfaces	4 x 10 Gigabit SFP+
MAC Address Table Size	16, 000 entries
Jumbo Frame Support	9198 bytes
Routing Protocol	OSPF, BGP, EIGRP, RIP
Remote Management Protocol	SNMP 1, SNMP 2, SNMP 3, RMON, SSH, Telnet, HTTP, HTTPS
Features	VLAN support, Quality of Service (QoS), ACL support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.3ab, IEEE 802.3ae
Voltage Required	AC 120/230 V (50 - 60 Hz)
Stacking	Stackable
Operating Temperature	32 to 104°F (0 to 40°C)