Cisco C9200L-24T-4X User Manual

Specifications for the Power Supplies and Fans
Table 20: Power Specifications for the AC Power Supplies
Power Requirements
• PWR-C5-1KWAC: 1000 W
• PWR-C5-600WAC: 600 W
• PWR-C5-125WAC: 125 W
Maximum output power
100 to 240 VAC(autoranging) 50-60 HzInput voltage and Frequency
• PWR-C5-1KWAC: 12-6A
• PWR-C5-600WAC: 7-2.8A
• PWR-C5-125WAC: 1.6-0.7A
Input current
• PWR-C5-1KWAC: 54V @ 18.5A
• PWR-C5-600WAC: 54V @ 11.1A
• PWR-C5-125WAC: 12V @ 10.5A
Output ratings
• PWR-C5-1KWAC: 3412 BTUs per hour, 1000W
• PWR-C5-600WAC: 2047.3 BTUs per hour,
600W
• PWR-C5-125WAC: 426.5 BTUs per hour, 125W
Total output BTU
Table 21: Fan Module Environmental and Physical Specifications
Environmental Ranges
23 to 176°F (–5 to 80°C)
Operating temperature
–40 to 185°F (–40 to 85°C) up to 15,000 ft (4500 m)Storage temperature
5 to 95% (noncondensing)Relative humidity
Up to 13,000 ft (4000 m)Altitude
Physical Specification
1.62 x 1.73 x 4.24 in. (4.11 x 4.39 x 10.76 cm)
Dimensions (H x D x W)
0.48 lb (0.21 kg)Weight (for three fans)
Operating Specification
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
72
Technical Specifications
Specifications for the Power Supplies and Fans

Cisco C9200L-24T-4X Specifications

General

Model	C9200L-24T-4X
Device Type	Switch
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
DRAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Ports	24 x 10/100/1000
Uplink Interfaces	4 x 10 Gigabit SFP+
MAC Address Table Size	16, 000 entries
Jumbo Frame Support	9198 bytes
Routing Protocol	OSPF, BGP, EIGRP, RIP
Remote Management Protocol	SNMP 1, SNMP 2, SNMP 3, RMON, SSH, Telnet, HTTP, HTTPS
Features	VLAN support, Quality of Service (QoS), ACL support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.3ab, IEEE 802.3ae
Voltage Required	AC 120/230 V (50 - 60 Hz)
Stacking	Stackable
Operating Temperature	32 to 104°F (0 to 40°C)