Cisco Catalyst 3120 Hardware Installation Guide

2-19
Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
OL-12246-01
Chapter 2 Switch Installation
Installing Devices in the 10-Gigabit Ethernet Slots
Figure 2-12 Installing X2 Transceiver Modules
Caution Do not install the converter module with SFP modules or cables installed. Always remove any cables and
modules before installing the converter module in the slot.
Figure 2-13 Installing Converter Modules
Removing a Module
To remove an X2 transceiver module or a converter module, follow these steps:
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2 For X2 transceiver modules, disconnect the cables from the module. For fiber-optic modules, install the
optical bore dust plugs.
Step 3 For converter modules, disconnect the cables from the SFP module. Remove the SFP modules from the
converter module.
Caution Do not remove the converter module with SFP modules or cables installed. Always remove any cables
and modules before removing the converter module from the slot.
Step 4 Carefully pull on the X2 module sleeve, or pinch the tabs on the converter module to disengage it from
the slot. Grasp the edges of the module, and carefully slide it out of the slot.
250299
2
4
x
SFP19-20
19-20
21-22
S
Y
S
T
S
-M
O
D
E
S
-M
S
T
R
S
-M
M
B
R
C
O
NS
O
LE
W
S-CBS312
0G-S
M
O
D
E
U
ID
SFP 21-22
23
x
2
6
x
STK A
STK B
250300
2
4x
SFP19-20
19-20
21-22
S
Y
S
T
S
-M
O
D
E
S
-M
S
T
R
S
-M
M
B
R
C
ON
S
O
LE
W
S-CBS312
0G-S
M
O
D
E
UID
SFP 21-22
2
3
x
2
6x
STK A
STK
B

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English