Cisco Catalyst 3120 Hardware Installation Guide

C-1
Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
OL-12246-01
APPENDIX
C
Configuring the Switch with the CLI-Based
Setup Program
This appendix provides a quick installation and setup procedure for the switch module by using the
command-line interface (CLI).
Note For detailed installation procedures, see Chapter 2, “Switch Installation.” For product overview
information, see Chapter 1, “Product Overview.”
These are the major steps for a quick installation when using the CLI:
1. Accessing the CLI Through the Console Port, page C-1
2. Connecting to the Console Port, page C-1
3. Completing the Initial Configuration, page C-4
Accessing the CLI Through the Console Port
You can access the CLI on a configured or unconfigured switch module by connecting the console port
of the switch module to the serial port on your PC or workstation and accessing the switch module
through a Telnet session.
Connecting to the Console Port
Obtain and make note of this information from your network administrator before you begin the switch
module installation:
• Switch IP address
• Subnet mask (IP netmask)
• Default gateway (router)
• Enable secret password (encrypted)
• Enable password (not encrypted)
• Telnet password
• SNMP community strings (optional)

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English