Cisco Catalyst 3120 - Page 4

Contents
4
Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
OL-12246-01
Installing the Switch Module in the Blade Enclosure 6
Switch Module IP Addresses 8
Using the Onboard Administrator to Assign an IP Address to the Switch Module and Running Express
Setup 9
Using Express Setup 11
Setting the Installed Switch Module As the Stack Master 12
Refreshing the PC IP Address 13
Planning and Creating a Switch Stack 13
Stack Cabling Configurations 14
Connecting to the StackWise Plus Ports 16
Installing Devices in the 10-Gigabit Ethernet Slots 17
Installing X2 Transceiver Modules and Cisco Converter Modules 18
Installing SFP Modules 20
Connecting to the 10/100/1000 Ports 22
Planning 10/100/1000 Ethernet Port Connections 23
Where to Go Next 24
CHAPTER 3 Troubleshooting 1
Diagnosing Problems 1
Verify the Switch Module POST Results 1
Look at the Switch Module LEDs 2
Confirm the Switch Module Connections 2
Verify the Switch Module Performance 4
Clearing the Switch Module IP Address and Configuration 5
Replacing a Failed Stack Member 5
Locating the Switch Module Serial Number 6
APPENDIX A Technical Specifications 1
APPENDIX B Connector and Cable Specifications 1
Connector Specifications 1
10/100/1000 Ports 1
10-Gigabit Ethernet Module Interfaces 3
Cisco TwinGig Converter Module Ports 3
Console Port 4
Cable and Adapter Specifications 4
10-Gigabit Ethernet X2 Transceiver Module Cable Specifications 4
SFP Module Cable Specifications 6