Cisco CRS-1 - Carrier Routing System Router

3-3
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
show controllers egressq clients
show controllers egressq clients
To display the list of clients connected to the egress queue manager, use the show controllers egressq
clients command in EXEC mode..
show controllers egressq clients location node-id
Syntax Description
Command Default No default behavior or values.
Command Modes EXEC
Command History
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. If you suspect user group assignment is preventing you from using a command, contact your
AAA administrator.
Task ID
Examples The following example shows how to use the show controllers egressq clients command:
RP/0/RP0/CPU0:router# show controllers egressq clients location 0/6/cpu0
Mon Sep 27 00:35:08.433 DST
---------------------------------------------------------------
Egressq Clients
---------------------------------------------------------------
Name PID State registers Last-State-Changed
---------------------------------------------------------------
QOS_EA 131187 OPEN 1 Tue Sep 14 23:24:45 2010
hfr_pm 98389 OPEN 1 Tue Sep 14 23:24:18 2010
feature_mgr 98408 OPEN 1 Tue Sep 14 23:24:16 2010
Table 1 describes the significant fields shown in the display.
location node-id The egress queue manager location. The node-id argument is entered
in the rack/slot/module notation.
Release Modification
Release 4.0.0.T This command was introduced.
Release 4.0.1 No modification.
Release 4.0.2 No modification.
Task ID Operations
drivers read