EasyManua.ls Logo

Cisco CRS-1 - Carrier Routing System Router

Cisco CRS-1 - Carrier Routing System Router
250 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-83
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
Configuration Examples for Migrating to a Cisco CRS-3 Carrier Routing System
0/SM9/SP FC-140G/S(SP) N/A IOS-XR RUN PWR,NSHUT,MON
The fabric cable is attached to the FC-140G/S card at this point.
RP/0/RP1/CPU0:router(admin)# configure
RP/0/RP1/CPU0:router(admin-config)# do show controllers fabric plane 0 detail
...
Plane Admin Oper Down Total Down
Id State State Flags Bundles Bundles
------------------------------------------------------
0 DOWN DOWN pPm 9 6
RP/0/RP1/CPU0:router(admin-config)# do show controllers fabric plane 0 detail
...
Plane Admin Oper Down Total Down
Id State State Flags Bundles Bundles
------------------------------------------------------
0 DOWN DOWN P 9 6
RP/0/RP1/CPU0:router(admin-config)# no controllers fabric plane 0 shutdown
RP/0/RP1/CPU0:router(admin-config)# commit
RP/0/RP1/CPU0:Mar 4 18:47:42.930 : fsdb_aserver[173]: %FABRIC-FSDB-1-PLANE_UPDOWN : Plane
0 state changed to UP:
RP/0/RP1/CPU0:Mar 4 18:47:42.954 : config[65733]: %MGBL-LIBTARCFG-6-ADMIN_COMMIT :
Administration configuration committed by user 'user_a'.
RP/0/RP1/CPU0:router(admin-config)# end
RP/0/RP1/CPU0:router(admin)# show controllers fabric plane all
Flags: P - plane admin down, p - plane oper down
C - card admin down, c - card oper down
L - link port admin down, l - linkport oper down
A - asic admin down, a - asic oper down
B - bundle port admin Down, b - bundle port oper down
I - bundle admin down, i - bundle oper down
N - node admin down, n - node down
o - other end of link down d - data down
f - failed component downstream
m - plane multicast down
Plane Admin Oper
Id State State
--------------------
0 UP UP
1 UP UP
2 UP UP
3 UP UP
4 UP UP
5 UP UP
6 UP UP
7 UP UP
Adding an LCC to a Cisco CRS-3 Carrier Routing System 16-Slot Line Card
Chassis: Example
The following example shows how to add an LCC to a Cisco CRS-3 Carrier Routing System 16-Slot Line
Card Chassis:

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Related product manuals