EasyManuals Logo
Home>Cisco>Network Router>CRS-1 - Carrier Routing System Router

Cisco CRS-1 - Carrier Routing System Router Migration Guide

Cisco CRS-1 - Carrier Routing System Router
250 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #136 background imageLoading...
Page #136 background image
2-38
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
OL-13669-03
Chapter 2 Downgrading Your Cisco CRS-3 Carrier Routing System Router Back to a Cisco CRS-1 Carrier Routing
System Router
Downgrading your Cisco CRS-3 Carrier Routing System 8-Slot Line Card Chassis Back to a Cisco CRS-1 Carrier Routing
System 8-Slot Line Card Chassis
Verify that each of the eight fabric planes is enabled by executing the show controllers fabric plane all
command:
RP/0/RP0/CPU0:router(admin)#show controllers fabric plane all
Plane Admin Oper up->dn up->mcast
Id State State counter counter
---------------------------------------------
0 UP UP 2 2
1 UP UP 2 2
2 UP UP 0 0
3 UP UP 0 0
4 UP UP 0 0
5 UP UP 0 0
6 UP UP 0 0
7 UP UP 0 0
Each plane transitions from UP -> MCAST_DOWN -> DOWN -> MCAST_DOWN -> UP. Thus each
plane will cycle through up->dn twice. This is why the up->dn counter shows 2. Similarly each plane
will cycle through mcast_dn->up twice as well and the mcast_dn->up counter shows 2.
Verifying Traffic Statistics on the Newly Downgraded Cisco CRS-1 Node
To ascertain that traffic is flowing on the downgraded Cisco CRS-1 fabric node please run the following
show controllers fabric plane 0 statistics detail command on both the planes that have been
downgraded. Run it a few times to ensure that the counters are incrementing. The lost or error counters
should not be incrementing.
The same show controllers fabric plane 0 statistics detail command should also be applied on the
Cisco
CRS-3 nodes that have not yet been downgraded to make sure there is no traffic lost or traffic with
errored cells.
RP/0/RP0/CPU0:router(admin)#show controllers fabric plane 0 statistics detail
Total number of providers for the statistics: 1
Total received data cells: 7063
Total received unicast data cells: 4487
Total received low priority unicast data cells: 4487
Total received high priority unicast data cells: 0
Total received multicast data cells: 2576
Total received low priority multicast data cells: 2050
Total received high priority multicast data cells: 526
Total transmitted data cells: 21094
Total transmitted unicast data cells: 4487
Total transmitted low priority unicast data cells: 4487
Total transmitted high priority unicast data cells: 0
Total transmitted multicast data cells: 16607
Total transmitted low priority multicast data cells: 13977
Total transmitted high priority multicast data cells: 2630
Total received correctable errored cells: 0
Total received uncorrectable errored cells: 0
Total received parity error cells: 0
Total received stomp cells: 0
Total received kill cells: 0
Total received unknown cells: 0
Total transmitted bogus cells: 4
Total transmitted statically routed control cells: 0
Total transmitted stomp cells: 0
Total transmitted kill cells: 0
Total transmitted ECI cells: 0
Total transmitted LCE cells: 0

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS-1 - Carrier Routing System Router and is the answer not in the manual?

Cisco CRS-1 - Carrier Routing System Router Specifications

General IconGeneral
BrandCisco
ModelCRS-1 - Carrier Routing System Router
CategoryNetwork Router
LanguageEnglish

Related product manuals