10-2
User Guide for Cisco Digital Media Player Device Manager 5.2.x
OL-15764-03
Chapter 10 Configure Settings for Touchscreens, Projectors, and Displays
Procedures
When you use a composite/S-Video cable to connect your DMP to an analog display:
• Display Standard — NTSC_M
• Display Output Interface — Composite/S-Video
• Color Space — None
• Color Component Order — RGB
Related Topics
• Adjust DMP Display Attributes, page 10-5
• UI Reference: Elements to Define Attributes of a DMP Display, page 10-7
Procedures
• Choose and Calibrate a Touchscreen Driver, page 10-2
• Configure Video Output, page 10-4
• Adjust DMP Display Attributes, page 10-5
• Adjust Horizontal and Vertical Settings, page 10-6
• Reprogram the Buttons on Your Handheld Remote Control, page 10-6
Choose and Calibrate a Touchscreen Driver
This procedure applies to you only if your DMP supports interactivity through touch and your
presentation system is a touchscreen. Furthermore, it assumes that you completed the “Connect to a
Touchscreen” section on page 6-7.
Before You Begin
• Verify that your DMP model supports touchscreen technologies and that we support the touchscreen
brand, model, and device driver that you will use. See http://www.cisco.com/go/dms/compatibility.
• Log in to DMPDM.
Procedure
Step 1 If your touchscreen shows a message that says it must download a touchscreen characterization file:
• Do not disturb or interrupt this process. It occurs only once, automatically.
• The process takes approximately 10 minutes to finish. When it is finished, your touchscreen will
clear the message automatically.
• Stop. You have completed this procedure and there is no need to perform any of its other steps.
Step 2 Because some touchscreen drivers cannot be calibrated on a DMP while it is playing video, use DMPDM
to stop all videos.
a. Click Video Multicast in the Display Actions list, and then click Stop.
b. Click Media URL in the Display Actions list, and then click Stop.
Step 3 Choose the browser rotation angle for your touchscreen.