11-13
User Guide for Cisco Digital Media Player Device Manager 5.2.x
OL-15764-03
Chapter 11 Configure Network Settings
Procedures
• WPA2-PSK
• WPA2-EAP
The security method that you choose controls, in part, which fields and options this DMPDM page
sho
ws to you.
• When you see the PSK field and you chose a WEP-based security method, enter in it the key
from which your 64-bit or 128-bit passphrase is cryptographically derived.
• When you see the PSK field and you chose a WPA-based or WPA-2-based security method,
enter in it the pre-shared key for your network.
• When you see the Encryption list, choose from it either TKIP or CCMP AES.
• When you see the EAP list, choose from it either FAS T, MD5, or PEAP (ver.0).
• When you see the Username and Password fields, enter in them respectively a valid username
for your wireless network and the password for that username.
c. Choose Enabled from the Dynamic IP Addressing (DHCP) list.
Tip Will you ever deploy your DMP in a wireless network that does not have any DHCP server? If so, you can
configure your DMP to use a static IP address.
d.
(Optional) Click Probe to check whether these settings work correctly with your wireless network.
e. When you are satisfied with your choices, Click Select.
f. Click Save Configuration in the Administration list, and then click Save.
Step 4 Disconnect the Ethernet cable from your DMP.
Step 5 Click Restart DMP in the Administration list, and then click Restart.
Step 6 Stop. You have completed this procedure.
Related Topics
• Physical Interfaces (I/O Ports), page 2-4
• Connect Over Ethernet, page 2
• Assign a Static IP Address to a Wireless DMP 4400G, page 11-16
To Next Page
Loading...
Need help?
General
