Statement 7013—Equipment Bonding Networks CBN
This equipment is suitable for installations utilizing the insert CBN.
Note
Statement 7016—Battery Return Conductor
The battery return conductor of this equipment shall be treated as DC-1.
Note
Statement 7017—Minimum Steady State DC Input Voltage
This equipment operates without degradation at a minimum steady state voltage of -40.5 VDC. The nominal
DC input voltage rating is -48 VDC.
Note
Statement 8015—Installation Location Network Telecommunications Facilities
This equipment is suitable for installation in network telecommunications facilities.
Note
Statement 8016—Installation Location Where the National Electric Code (NEC) Applies
This equipment is suitable for installation in locations where the NEC applies.
Note
Safety Recommendations
Observe these safety guidelines:
• Keep the area clear and dust-free before, during, and after installation.
• Keep tools away from walkways, where you and others might trip over them.
• Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains that could get caught in the
chassis.
• Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
• Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
• Never attempt to lift an object that is too heavy for one person.
Cisco Firepower 4110, 4120, 4140, and 4150 Hardware Installation Guide
43
Installation Preparation
Safety Recommendations
To Next Page
Loading...
